Acrosser AR-B9612 Manuel d'utilisateur télécharger pdf (Page 37)

4-6 AR-B9612 User’s Guide

4.2.3 Hard Disk Setup

The BIOS supported 48 types for user setting, The BIOS

supported <Pri Master> and <Pri Slave> two items that user can

install up to two hard disks. The master and slave jumper

adjusting, please refer to the hard disk’s installation description

and the hard disk jumper setting.

CAUTION: AR-B9612 can not support the 32Bit Transfer, so

Acrosser recommends user configure the <32Bit>

field is always [Off], not setting [On].

You can select <AUTO> under the <TYPE> and <MODE> fields.

This will enable auto detection of your IDE drives during bootup.

This will allow you to change your hard disk drives (with the

power off) and then power on without having to reconfigure your

hard drive type. If you use older hard disk drives which do

not support this feature, then you must configure the hard disk

drive in the standard method as described above by the

<USER> option.

The user type referring to the hard disk type setting, it always

sets the <Cyln>, <Head> and <Sec> the three items, the BIOS

will find the hard disk size.

4.2.4 Virus Protection

This option protects the boot sector and partition table of your

hard disk against accidental modifications. Any attempt to

write to them will cause the system to halt and display a warning

message. If this occurs, you can either allow the operation to

continue or use a bootable virus-free floppy disk to reboot and

investigate your system. The default setting is Disabled. This

setting is recommended because conflicts with new operating

systems. Installation of new operating systems require that

you disable this to prevent write errors.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 46 47

Pas de commentaire

Acrosser AR-B9612 Manuel d'utilisateur Page 37