Acrosser AR-B9612 Manuel d'utilisateur télécharger pdf (Page 19)

2-14 AR-B9612 User’s Guide

Software Programming

You can use the DOS <FORMAT> and <COPY> command to

format and copy files. Follow the following steps to format

and copy files to the FLASH disk.

Step 1:

Turn on your computer, when the screen shows the

SSD BIOS menu, please hit the [F1] key during the

system boot-

up, this enables you to enter the FLASH

setup program.

Step 2:

Use <Page-Up>, <Page-Down>, <Right>, and <Left

arrow keys to select the correct FLASH memory type

and how many memory chips are going to be used.

Step 3:

Press the [F4] key to save the current settings.

Step 4:

After the DOS is loaded, use the DOS [FORMAT]

command to format the FLASH disk

To format the disk and copy DOS system files to the

disk.

C:\>FORMAT [ROM disk letter] /S /U

To format the disk without copying DOS system files.

C:\>FORMAT [ROM disk letter] /U

Step 5:

Copy your program or files to the FLASH disk by using

DOS [COPY] command.

CAUTION:

It is not recommended that the user format the disk

and copy files to the FLASH disk very often.

Since the FLASH EPROM’s write cycle life time is

about 10,000 or 100,000 times, writing data to the

FLASH EPROM chips, especially the

FLASH

EPROM chips, especially the FLASH EPROM chip

in the MEM1 socket.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 46 47

Pas de commentaire

Acrosser AR-B9612 Manuel d'utilisateur Page 19