Acrosser AR-B1651 Manuel d'utilisateur télécharger pdf (Page 24)

AR-B1651 User’s Guide

5.6 PCI/PLUG AND PLAY

This section is used to configure PCI / Plug and Play features. The <PCI & PNP Setup> option configures the PCI

bus slots. All PCI bus slots on the system use INTA#, thus all installed PCI cards must be set to this value.

PCI / Plug And Play

Plug and Play Aware O/S

Set this option to Yes if the operating system installed in the computer is Plug and Play-aware. The BIOS only

detects and enables PnP ISA adapter cards that are required for system boot. The Windows 95 operating system

detects and enables all other PnP-aware adapter cards. Windows 95 is PnP-aware. Set this option <No> if the

operating system (such as DOS, OS/2, Windows 3.x) does not use PnP. You must set this option correctly or

PnP-aware adapter cards installed in your computer will not be configured properly.

Clear NVRAM

This sets the operating mode of the boot block area of the BIOS FLASH ROM to allow programming in the Yes

setting.

OnChip VGA Frame Buffer Size

This option sets VGA Frame Buffer Size .It can set up None .2MB.4MB.8MB

PCI Latency Timer (PCI Clocks)

This option sets latency of all PCI devices on the PCI bus. The settings are in units equal to PCI clocks.

Primary Graphic Adapter

This option is set to use PCI bus or AGP. The AGP mode will get system a faster processing speed.

DMA & IRQ

These options specify the bus that the named IRQs/DMAs lines are used on. These options allow you to specify

IRQs/DMAs for use by legacy ISA adapter cards. These options determine if the BIOS should remove an IRQ/DMA

from the pool of availability of IRQs/DMAs passed to the BIOS configurable devices. If more IRQs/DMAs must be

removed from the pool, the end user can use these PCI/PnP Setup options to remove the IRQ/DMA by assigning

the option to the ISA/EISA setting. The onboard I/O is configurable with BIOS.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29

Pas de commentaire

Acrosser AR-B1651 Manuel d'utilisateur Page 24